MFP-3 PDF Notes – Unit 5 – Mech Branch

Other Relative Links

MFP-3 PDF Notes - Unit 5

Topics Covered - MFP-3 Pdf notes of unit 5 are listed below:

MANUFACTURING PROCESS – III Notes (MFP-3)
UNIT -5

  • Drawing.
  • Drawing equipment & dies.
  • expression for drawing load by slab analysis.
  • power requirement.
  • Redundant work and its estimation.
  • optimal cone angle & dead zone.
  • formation.
  • drawing variables.
  • Tube drawing.
  • classification of tube drawing.
  • simple problems.


Leave a Reply

Your email address will not be published. Required fields are marked *