Machine Drawing Important Questions – MD Imp Qusts

5
(7)

Machine Drawing Important Questions Pdf file – MD Imp Qusts

Please find the attached pdf file of Machine Drawing Important Questions Bank – MD Imp Qusts

Link – MD Question Bank

UNIT- I

  1. Give the proportions of a hexagonal nut, in terms of the nominal diameter of the bolt of 20 mm.
  2. Draw the three views of a hexagonal headed bolt of nominal diameter 25 mm and length 100 mm; with a hexagonal nut and washer.
  3. Draw the half sectional view from the front, with top view knuckle joint , to connect two rods of 30 mm diameter each

For more questions please download the above Pdf file

UNIT-II

  1. Assemble the parts of a foot-step bearing, shown in Fig. 13 and draw, (i) sectional view from the front and (ii) view from above.
  2. Assemble the parts of a spring loaded relief valve, shown in Fig. 11 and draw the following views:(i) Sectional view from the front, and(ii) View from the right.

For more questions please download the above Pdf file

UNIT-III

  1. Draw the sectional view from the front, and view from the side of a cotter joint with sleeve used to connect two rods of 30 mm diameter each.
  2. Draw the half sectional view from the front, with top view knuckle joint , to connect two rods of 30 mm diameter each

For more questions please download the above Pdf file

le

UNIT-IV

  1. .Assemble the parts of the feed check valve, shown in Fig. 10 and draw, (i) sectional view from the front, (ii) view from the right and (iii) view from above.
  2. Figure 6, shows the details of a lathe tail-stock. Assemble the parts and draw to a
    suitable scale, (i) sectional view from the front and (ii) view from the left.

For more questions please download the above Pdf file

How useful was this post?

Click on a star to rate it!

Average rating 5 / 5. Vote count: 7

No votes so far! Be the first to rate this post.

Leave a Reply

Your email address will not be published. Required fields are marked *